Tube Cutters
Elliott’s One-Revolution Series tube cutters are unlike any other one-revolution cutter. Using more advanced engineering principles the cutter and blade have been designed to last longer, withstand more wear, and require less force to cut the tube.
-
Tube Size: 0.375" to 2.500" (9.53 - 63.5mm) OD
-
Reach: 6" & 12" (152.4 & 304.8mm)
-
Type: Tube Cutter
-
Great For Puncturing Or Cutting
PTTC Series
Tube Cutter
Elliott’s PTTC (Push Type Tube Cutter) Series Cutters accommodate heat exchangers and boilers. The adjustable collar allows tubes to be cut or scored just beyond the tube sheet. The cutting blades are specially coated to increase longevity.
-
Tube Size: 0.375” to 2.500” (9.5 – 63.5mm) OD
-
Type: Tube Cutter
-
Tube Sheet Thickness: 5" - 12" (127.0 - 304.8mm)
-
Non-Ferrous/Steel or Stainless Steel Cutter Blades
300 Series
Boiler Tube Cutter
Elliott’s 300 Series Boiler Tube cutters are power driven to cut tubes to length in Firetube and Watertube boilers prior to roll beading.
-
Tube Size: 2.000" to 3.000" (50.8 - 76.2mm) OD
-
Type: Tube Cutter
-
Male Square Drive: 1" (25.4mm)
-
Drive Source: Motors with ≤ 150 RPM or Ratchet
Suggested Articles
Installing Mechanical Tube Plugs
When needing to use and install mechanical tube plugs, having the correct tools for the job can make it easier and quicker to get the job. Below are step by step instructions to help overcome this challenge.
Elliott’s One-Rev Tube Cutter Produces 24X More Punctures Than The Competition
Elliott's One-Rev deploys more advanced engineering principles with over 12 key differences that result in a superior product. The One-Rev cutter blade is designed to withstand even the toughest of materials.
Why Vent Tubes?
One of the most overlooked best practices for plugging a tube is to vent the tube beforehand. Tube venting is a process by which a small puncture is made inside of the tube, releasing any pressure or chemicals that may be trapped inside.